Bissell 1200-B User's Guide download pdf (Page 8)

How to begin continued

1. Surface Stain Cycle This cycle has been

designed for stains that are on the surface of

your carpeting and have not had time to

penetrate deep in to your carpet fibers. This

cycle will run for approximately 3 minutes.

2. Set-In Stain Cycle Use on stains that have

had a period of time to set-in and penetrate

deep into your carpet fibers. These are typically

the most difficult stain types to remove. This

cycle runs for approximately 6 minutes.

3. Manual / Hose By selecting this option you can

clean spots and stains manually on surfaces

such as upholstery, car interiors, stairs or

anyplace you have a need to clean manually

4. Pause/Resume Is used to check the

status of a cleaning cycle (Surface Stain or

Set-In). If you hit the Pause button once, it

pauses the cleaning cycle it is currently in.

By pressing it one more time to Resume,

you will pick up in the cleaning cycle

where you left off.

5. Stop By depressing the Stop button, you

will stop your SpotBot in either the Surface

or Set-In stain cycle. To begin cleaning

again, you will need to select one of the 2

cycles.

6. Status Indicators Much like the

dishwasher in your kitchen, the Status

Indicators will instruct you as to what is

going on within a cleaning cycle. You will

hear changes in the sound of the machine

at different points in a cycle. When your

selected cleaning cycle is complete, the

Finish light will illuminate and you will

hear a “beep” every 5 seconds until you

depress the stop button.

8

www.bissell.com 800.237.7691

Operation

Tip:

Some spots and spills

require that you pick up the

chunky debris with a rag

or towel before you begin

cleaning in the Handsfree or

Manual cycles.

ug120-4070_1200_408.indd 8 10/14/08 1:07:43 PM

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments