Bissell 1200-B User's Guide Page 10

  • Download
  • Add to my manuals
  • Print
  • Page
    / 16
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 9
Manual/hose cleaning
1. Remove the hose from the unit by
depressing the release button.
2. a. Remove the Tough Stain Brush from the
back of the unit.
b. Attach the Tough Stain Brush onto the
grip of the flex hose.
3. Select the manual/hose button on the
control panel to start the SpotBot.
NOTE: In manual mode, the SpotBot will not
turn on until the grip is removed from the
unit. If it is not removed within 30 seconds
of pushing the start button, the unit will
shut off.
4. Begin cleaning by holding the tool no more
than six inches above the soiled surface.
Depress the spray trigger for about
5 seconds to apply the cleaning solution to
the soiled area. Release the trigger. Be
careful not to over wet.
5. Using the brush on the tool, gently scrub the
soiled area for about 30 seconds or until the
soiled area appears to be clean.
6. To suction up the dirt and cleaning solution,
position the suction nozzle over the cleaned
area, apply downward pressure on the tool,
and pull nozzle toward you. You should see the
dirty solution pass through the nozzle. Continue
until no more solution can be removed.
Normally, this step will require no more than
one minute of back and forth passes.
NOTE: In manual mode, the SpotBot is
equipped with a safety feature which will
shut the unit off after 30 minutes. Press
start to resume cleaning.
7. If the stain is still visible, repeat steps 4-6
as necessary.
8. When the cleaning is complete, lightly drag
the suction nozzle across the stain for about
two minutes to further aid in drying the
cleaned area.
9. Press the Manual/Hose button to turn off
the SpotBot.
10. Unplug the machine, wrap the cord on the
cord wraps and wrap the hose around the
machine so that the wand can be placed in
the holder for convenient storage.
10
www.bissell.com 800.237.7691
Operation
Tip:
Check upholstery stuffing
before cleaning. Colored
stuffing may bleed through
the fabric when it becomes
wet.
Tip:
One of the effective stain
removing ingredients in Oxy
Gen2 is Hydrogen Peroxide.
Certain people may be
affected by the product
when it comes into contact
with their skin; it may turn
the skin white and/or cause
tingling. Washing your hands
after use and applying hand
lotion will remove any
possible white discoloration.
1 2a
2b 3
ug120-4070_1200_408.indd 10 10/14/08 1:07:47 PM
Page view 9
1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments