Bissell 1200-B User's Guide download pdf (Page 9)

To begin cleaning

1. Plug your SpotBot in. The Power light will illumi-

nate instructing you that there is power to the

unit and it is ready to go.

2. Place the filled Clean/Solution tank on to the

unit

Handsfree cleaning

1. Place the unit directly over the spot or stain,

making sure the stain is in the center of the

handsfree cleaning area.

2. Select which cleaning cycle (surface stain or

set-in) you would like to begin with. Your

SpotBot will begin spraying, brushing and

suctioning up the spots and stains, in its

pre-programmed cycle. Both cycles have

been tested and proven to deliver superior

cleaning results, taking the guesswork out of

cleaning for you.

3. When the cleaning cycle you have selected

is complete, the SpotBot will beep. The beep

will continue until you hit the STOP button.

4. Pick up the unit and check the area that

was cleaned.

5. If you have used Oxy GEN2, this chemical

will continue to work for the next six to eight

hours. Cleaning your spots and stains all the

way to the backing of the carpet.

Operation

www.bissell.com 800.237.7691

Tip:

Some difficult stains may

require that you run the

cleaning cycle a second

time.

ug120-4070_1200_408.indd 9 10/14/08 1:07:44 PM

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

No comments

Bissell 1200-B User's Guide Page 9