Bissell 25A3 User Manual download pdf (Page 11)

1. Plug the deep cleaner Into a proper outlet.

Set ReadyTools dial to the Floor Cleaning

setting. Turn the power on by pressing the

red power switch on the back of the unit

with your foot. Turn heater switch (located

on side of unit) to the on position. Allow one

minute for the bullt-ln heater to warm up

before cleaning.

NOTE: The ProHeat will be fully warmed

and will provide optimal performance after

a minute of continuous heated cleaning.

2. With your foot, press the gray handle release

lever located on the back of unit below

water tank to detent handle.

3. While pressing the spray trigger, make one

slow forward wet pass and another back.

Let the built-in heater, BISSELL advanced

deep cleaning formula, and DirtLifter

PowerBrush do the work for you.

Caution: Do not overwet.

4. Release the spray trigger and make one

slow forward and backward pass over the

same area to remove any residual dirty

water and aid in drying.

5. Repeat cleaning passes until solution

being suctioned up appears clean. Continue

passes without pressing the trigger until

you can’t see any more water being

suctioned up.

Operation

Carpet cleaning

Tip:

Handle Release

Power Switch

Heater

Switch

WARNING:

To reduce the risk of fire

and electric shock due to

internal component

damage, use only BISSELL

cleaning fluids intended for

use with the deep cleaner.

Non-BISSELL cleaning

solutions may harm the

machine and void

the warranty.

WWW,bissei

80 0,2 3 7,769 1

11

ug120-4078_25A3_908.indd 11 10/14/08 1:21:05 PM

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Comments to this Manuals

No comments