Bissell OPTICLEAN User's Guide download pdf (Page 10)

Maintenance and care

The Pre-motor Filter prevents dust

and debris from interfering with

the operation of your vacuum. It

should be regularly checked for

wear or damage and replaced

when torn.

1. Turn the power OFF ( ). Unplug the

vacuum from electrical outlet.

2. Disconnect hose.

3. Open the dust bag compartment by lifting

up on the door latch at the front of the

vacuum. Follow the instructions on page

9 to remove and dispose of the dust bag.

4. Remove the filter frame from the filter hold-

er by gently pressing down on the top tab

and pulling the filter frame up and away

from the filter holder.

5. Remove the filter from the filter frame and

clean by hand washing in warm water.

A mild detergent can be used if desired.

Allow the filter to air dry completely

before replacing.

6. Place the filter back into the filter frame

and replace back into the filter holder,

snapping it back into place.

NOTE: The filter frame should be

placed so that the protective frame

is visible.

7. Following the steps on page 9, replace

the dust bag, making sure the entire back

is tucked in below the seal gasket.

8. Close dust bag compartment door and

press down gently until it locks into place.

9. Reconnect the hose.

NOTICE:

This product is intended for household

use only and not for commercial or

industrial use. Vacuuming of dust

from products like plaster, concrete or

ashes will damage the motor and void

the warranty.

Tip:

For maximum cleaning

performance, check the filters often

and clean or replace if necessary.

WARNING:

Do not operate cleaner with

damp or wet filters or

without all filters in place.

Cleaning the Pre-Motor Filter

Pre-Motor

Filter

4.

www.bissell.com 800.237.7691

10

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments