Bissell CleanView 3593 User Manual download pdf (Page 6)

Position the Hose Assembly on the back of the

vacuum as shown.

Attach the Hose with the remaining two screws from

the packet. Tighten securely with a screwdriver.

For Models with the Twist ‘n Snap

™

Hose

Position the Twist ‘n Snap Hose assembly on the

back of the vacuum.

Line up the tabs on the base of the Twist ‘n Snap

Hose with the corresponding notches on the hose

collar as shown.

Turn the Twist ‘n Snap Hose to the right to lock

the hose into place.

Grasping the Quick Reach Handle, slide the end of

the Hose Wand onto the Hose Wand Base. Snap the

Hose into the Hose Clip.

NOTE: The Powerfoot will not operate

effectively unless the Hose Wand is

firmly attached.

Slide the Extension Wand and the Crevice Tool

together into the storage clip as shown.

Slide the Dusting Brush/Upholstery Tool into the storage clip

as shown.

Attach the TurboBrush by aligning the small holes near the

brush roll with the tabs at the bottom of TurboBrush hous-

ing. Snap TurboBrush into place as shown.

Attach Vacuum Hose and Tools

NOTICE:

The Floor Brush will continue to rotate

while you use your vacuum for above

floor cleaning. To prevent carpet

damage, do not lean on the vacuum or

let the Powerfoot tilt forward

Select Models Only

Twist ‘n Snap Hose Models

CAUTION:

Before using your vacuum,

make sure that the Dirt

Container and Upper Tank are

in locked position and that all

filters (UpperTank, Pre-Motor

and Post-Motor) are in place.

Do not operate your vacuum

without these filters.

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Comments to this Manuals

No comments

Bissell CleanView 3593 User Manual Page 6

Comments to this Manuals

Related products and manuals for Vacuum cleaners Bissell CleanView 3593