Bissell CleanView 3593 User Manual download pdf (Page 12)

Grasp Rotating Floor Brush at both ends and lift.

Clean strings, hair and other debris from Rotating Floor

Brush, paying particular attention to brush ends.

Clean strings, hair and other debris from Motor Pulley and

Drive Belt areas.

Check Drive Belt carefully for wear, cuts or stressed areas.

Check Air Passageway for obstructions. Remove debris

from this area.

Unplug cleaner from electrical outlet.

With Rotating Floor Brush removed from vacuum cleaner

(Steps 1-4 of check Rotating Floor Brush and Drive Belt),

grasp old Drive Belt and remove from Motor Pulley.

Discard old Drive Belt.

Place new Drive Belt over Motor Pulley and stretch other end

over Rotating Floor Brush in the space between the bristles.

Place ends of Rotating Floor Brush down into slots on

sides as shown.

Turn Rotating Floor Brush by hand several times in the

direction of Motor Pulley. If properly installed, Drive Belt

will center itself on Rotating Brush crown.

Reposition Brush Cover and screw or snap back into place.

Check to be sure all screws or latches are secure.

Unplug cleaner from electrical outlet.

Using a screwdriver, remove the two screws as shown

and lift off the lens.

Remove the bulb from the socket by pushing in gently

and turning it counterclockwise. Install the new bulb by

pushing it gently into the socket and turning clockwise.

Reposition lens and secure with the two screws.

Select Models Only

The TurboBrush should be checked regularly for clogs

or debris wrapping around the brush roll.

Unplug vacuum from electrical outlet.

If a clog is present or debris is visible, unscrew the two

screws on the back of the TurboBrush to remove the

faceplate and clear any obstructions.

To clean debris from the brush roll, remove the screw

located by the brush roll with a Phillips head screwdriver.

Lift the belt cover. Remove the brush roll from the drive

belt and clean debris.

Replace Lightbulb

Maintaining Optional TurboBrush

Replace Drive Belt

Check Rotating Floor Brush and Drive Belt Continued

Air Passageway

Motor Pulley

1 2 ... 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

Bissell CleanView 3593 User Manual Page 12

Comments to this Manuals

Related products and manuals for Vacuum cleaners Bissell CleanView 3593