Bissell 51C1 Series User's Guide download pdf (Page 6)

w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1

Operations

6

Transporting your cleaner

Use the handle on the front to carry

the cleaner or place the cleaner in the

upright position and tip back to roll on

the rear wheels.

Releasing the power cord

The upper and lower cord wraps rotate

to allow for quick and easy removal of

the power cord.

Fingertip power switch

The power button is located at the top

of the vacuum handle.

To turn cleaner ON, press button once.

To turn cleaner OFF, press button again.

Note: The rotating brush will not turn

on unless the unit is in the reclined

position and the brush switch is on.

Handle positions

Use your foot to pull the handle release

pedal back to recline the vacuum cleaner.

Height adjustment

There are seven height settings available for

various floor surfaces. Turn the dial on the

foot of the cleaner to the desired setting.

Lowest setting – For low pile carpet or

bare floors. To pick up debris it may be

necessary to move up one setting.

Medium settings – For medium pile carpet.

High setting – For high pile and most

shag/frieze carpet.

Note: For optimal carpet cleaning

performance, adjust to the lowest

practical setting. If your cleaner is

difficult to push, adjust to the next

higher setting.

Caution: For Frieze style carpets,

it is recommended that the rotat-

ing brush be switched OFF when

vacuuming. Please check with your

carpet manufacturer for additional

cleaning tips.

If the dial is difficult to turn, tilt the

cleaner back slightly to take the weight

off the foot while turning.

ATTENTION:

Some Berber carpets have a

tendency to fuzz with wear.

Repeated strokes in the same

area may aggravate this

condition. Consider setting

your cleaner on a higher than

normal setting for this type of

carpet.

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Comments to this Manuals

No comments