Bissell PROHEAT 25A3 User Manual download pdf (Page 10)

w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1

Operations

10

Carpet cleaning

1. Plug the deep cleaner into a proper out-

let. Set ReadyTools dial to the "FLOOR

CLEANING" setting. Turn the power on

by pressing the red power switch on

the back of the unit with your foot. Turn

heater switch (located on side of unit)

to the on position. Allow one minute for

the built-in heater to warm up before

cleaning.

NOTE: The PROheat will be fully

warmed and will provide optimal

performance after a minute of con-

tinuous heated cleaning.

2. With your foot, press the gray handle

release lever (located on the back of unit

below water tank) to detent handle.

3. While pressing the spray trigger, make

one slow forward wet pass and another

back. Let the built-in heater, BISSELL 2X

advanced deep cleaning formula, and

DirtLifter PowerBrush do the work for you.

Caution: Do not overwet.

4. Release the spray trigger and make one

slow forward and backward pass over

the same area to remove any residual

dirty water and aid in drying.

5. Repeat cleaning passes until solution

being suctioned up appears clean.

Continue passes without pressing the

trigger until you can’t see any more

water being suctioned up.

Tip: Thorough vacuum-

ing before deep cleaning will

prevent early clogging of the

lint trap.

WARNING:

To reduce the risk of fire and electric

shock due to internal component

damage, use only BISSELL cleaning

fluids intended for use with the deep

cleaner. Non-BISSELL cleaning

solutions may harm the machine and

void the warranty.

Power Switch

Heater

Switch

Handle Release

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Comments to this Manuals

No comments