Bissell 3990 User Manual download pdf (Page 14)

14

www.bissell.com 800.237.7691

Maintenance and care

Replace drive belt

1. Unplug the vacuum from electrical outlet.

2. Press the brush roll on/off pedal in the

on position.

3. With rotating floor brush removed from

vacuum cleaner (Steps 1-4 of check

rotating floor brush and drive belt),

grasp old drive belt and remove from

motor pulley. Discard the old drive belt.

4. Loop new drive belt over motor pulley

and loop the bottom edge of the belt

under the belt disengager. Loop the other

end of the belt over the rotating floor

brush in the space between the bristles.

NOTE: It is important that you use only

genuine BISSELL replacement belts. Generic

belts may not meet the exact specifications

required to keep your vacuum operating at

its peak performance. The use of unbranded

belts could lead to early failure of the

vacuum and could void your warranty.

5. Pull the rotating floor brush firmly

into position, stretching the drive belt

and place ends of rotating floor brush

down into the slots on sides as shown.

Alignment of brush ends in slots may be

necessary to fully insert the brush.

6. Turn rotating floor brush by hand several

times in the direction of motor pulley. If

properly installed, drive belt will center

itself on rotating brush crown.

7. Insert front edge of brush cover, rotate

into place, and snap 3 latches.

Replace lightbulb

1. Unplug the vacuum from electrical outlet.

2. Using a flat bladed screwdriver, pry the tab

on the left and right side out and pull out to

remove the lens.

3. Remove the bulb from the socket by

grasping the bulb and pulling gently. Install

the new bulb by pushing it gently into the

socket until the bulb snaps into place.

4. Reposition the lens and snap it back

into place.

2.

3.

4.

Motor Pulley

4.

Belt

Disengager

ug603-2312_3990_507.indd 14ug603-2312_3990_507.indd 14 8/13/07 2:38:11 PM8/13/07 2:38:11 PM

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments