Bissell Velocity Vacuum User's Guide download pdf (Page 5)

www.bissell.com 800.237.7691

Assembly

5

2.

2.

Hose

Wand

Base

The only tool you’ll need to assemble your

vacuum cleaner is a Phillips-head screwdriver.

Attach handle to vacuum

1. Locate the vacuum handle and

remove the screw packet taped to it.

2. Stand the vacuum upright and slide

the base of the handle firmly into the

grooves at the top of the vacuum body.

3. Check to be sure the handle is fitted

to the vacuum body. If there is a gap

in front, continue to push firmly until

the handle is flush.

4. Insert the screw provided from the

screw packet into the existing hole.

Tighten securely with a screwdriver.

Attach vacuum hose and tools

1. Attach the Twist ‘n Snap™ hose by

lining up the tabs on the base with the

corresponding notches on the back of

the vacuum.

2. Turn the Twist ‘n Snap hose to the

right to lock the hose into place.

3. Grasping the Quick Reach handle,

slide the end of the hose wand onto

the hose wand base. Snap the hose

into the hose clip.

NOTE: The Powerfoot will not

suction properly unless the hose

wand is firmly attached.

4. Snap the extension wand and

the crevice tool together into the

storage clip.

5. Snap the combination tool into the

storage clip.

6. Attach the TurboBrush Tool by

aligning the small holes near the

brush roll with the tabs at the bottom

of TurboBrush Tool housing. Snap

TurboBrush Tool into place.

6.

4.

3.

4.

4.

5.

1 2 3 4 5 6 7 8 9 10 ... 15 16

Comments to this Manuals

No comments