Bissell QUICKWASH User's Guide download pdf (Page 6)

www.bissell.com

0perations

6

Carpet cleaning

1. With your foot, press the red power lever

[located in foot of unit] ON.

2. With foot, press the recline lever on left

side of lower body.

3. Depress spray trigger to spray cleaning

solution. Do not overwet.

4. To suction up water, repeat motion over same

area without pressing the spray trigger.

5. Repeat steps 3 and 4 until no more dirt

can be removed.

6. Continue to clean entire carpet, working

in 1m x 1m sections.

7. Empty the collection tank when dirty water

reaches the full line, or when the clean

water/solution tank is empty.

8. If floor nozzle stops spraying, turn

power lever OFF and check water and

cleaning solution levels. Refill if needed.

Empty collection tank

1. Turn power lever OFF and unplug power

cord from outlet.

2. Remove and empty collection tank.

a. Release collection tank latches [1 each

side] by pulling up from bottom of latch

and then out.

b. Carefully remove collection tank from

lower body by lifting handle.

c. Carry collection tank to a toilet or sink.

To empty, pour out contents using opening

at back of tank.

d. Rinse collection tank thoroughly.

e. Remove lint and hair from red gasket

in base of unit.

(Do not remove gasket)

3. Clean nozzle window by lifting latch

and removing from machine. Rinse under

running water. When finished replace

nozzle and secure with latch.

4. Replace collection tank on base of unit

and secure with latches.

Tip:

It is recommended

that every time your

clean water/solution

tank needs refilling, that

you empty the contents

of the collection tank. If

the collection tank gets

too full, you may begin

to see foam spitting out

of the vent cover. If this

happens empty the

collection tank.

3.

2c.

2b.

2e.

2a.

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments