Bissell BGUPRO18T Use and Care Manual download pdf (Page 8)

www.bissellcommercial.com 855.544.7336

Maintenance and care

8

Electronic Brush Alert

1. These lights should be monitored while

you are using the vacuum

Green Light: Operating properly

Green Light and Blinking Red Light:

Check brush drive. The belt is either of

the track or broken. Bring to Service

Center for repair or contact BISSELL

Red Light: Brush is not working prop-

erly. Unplug machine and inspect for

any type of obstruction. Bring to Service

Center for repair or contact BISSELL.

How to Replace the Brush

1. Remove the screw on the side of the

vacuum foot to access the brush

2. Pull out the brush strip

3. Replace brush strip with a new one by

sliding back in the brush “door”

4. If brush bristles do not extend above the

base plate a new brush assembly should

be ordered for your vacuum

Thermal Overload

The internal temperature of the

vacuum motor on the BG11 is moni-

tored at all times while you are vacu-

uming. If at any time the temperature

gets too high the sensor will shut

off the vacuum motor. Inspect the

units brush and hose for any type of

obstruction. The sensor will automati-

cally reset when the sensor and motor

are cooled. You can now restart the

motor.

WARNING:

Unplug the vacuum from electri-

cal outlet before attempting to

replace the brush

2.

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments